INSTALLATION INSTRUCTIONS

Mat the surface with abrasive material and remove the protective layer

The surface should be grounded before painting

Apply 2 coats of paint on the grounded surface

Skirting board can be painted after installation along with the wall

Separate the liner from sealing lip. It is recommended to clean the skirting board surface from dust and dirt for better adhesion

It is necessary to glue the sealing lip from the first try: precisely connect the sealing lip with the bottom of the skirting board. The position of the sealing lip cannot be adjusted after gluing

Skirting board with the sealing lip is ready for installation

Skirting board with the sealing lip reduces the penetration of moisture, dust and dirt, insects, and also serves as additional soundproofing

Insert the klammer into the skirting board. Insert the klammer in a section of the skirting board 15-20 cm long (for convenience you can use both sides), so that half of the klammer is visible

Put the marking on the wall. Press a piece of skirting board with klammer to the wall and floor, then insert the pencil into the cutout on the klammer. Move the skirting board section along the wall synchronously to create a marking for future dowel holes. Drill the holes and install the klammers on the dowels and screws after marking the wall

Install the skirting board on the klammers. The recommended distance between the klammers is 40-60 cm. Place the clamps on the corners close to each other so that the skirting board does not spring from the uneven floor. Similarly, use this method at the joints between skirting boards

Cut the corner stick 2 mm higher than the height of the skirtimg board or up to your discretion

Stick the sticker on the sidewall of the corner stick

Glue the corner stick at the junctions of the skirting board

The corner stick is used as a universal element for joining the skirting board in corners and its straight lines